JVC VR-N900U Startup Manual page 21

Note :
● Do not remove the check for Analog-In.
Memo :
● Priority is given to cameras at the top of the list during use, and
camera numbers will be registered in sequence from the top.
4
Use the [SKIP] button to select [Entry], followed
by pressing the [ZOOM IN/ENTER] button
● The camera that is automatically detected is registered in
the system.
5
Select the analog input channel and signal
format to be used
6
Use the [SKIP] button to select [OK], followed by
pressing the [ZOOM IN/ENTER] button
● The [Configure Device] screen appears.
7
Enter the password for the network camera
● Press the [KEY] button to display the software keyboard.
● Use the keypad to move the mouse cursor over the
software keyboard.
● Pressing the [ZOOM IN/ENTER] button inputs the
characters on the keyboard into the password field.
Memo :
● For cameras with the AAnalog-InB message (analog cameras),
7
proceed to Step . Password is not required. (VR-N900U)
8
After password entry is complete, press [KEY]
again the close the software keyboard
9
Use the [SKIP] button to select [OK], followed by
pressing the [ZOOM IN/ENTER] button
10
Repeat the steps from 5 to 7 for every detected
camera
● The [Camera Record Setting] screen appears.
11
Specify the display rate for each camera such
that the total display rate of all cameras does not
exceed 60 ips.
● The default display rate is set at 8 ips. The maximum
5
Note :
● The recording rate may drop if the total display rate of all
cameras exceeds 60 ips.
A
B
display performance of 60 ips will be exceeded if 8 or
more cameras are detected. In this case, you will need to
adjust the display rate of each camera using the following
steps.
Press the [SKIP] button to select Device Manager
● The device at the top is selected.
Use the [2/D] or [8/E] button to select a device
A
B
13