Argox X-3200ZE User Manual page 123

The simplest way to connect to other hosts (not PC compatible) or
terminals is:
Printer
Pin 2- RxData .........
Pin 3- TxData .........
Pin 5- Ground .........
In general, as long as the data quantity is not too large and you use
Xon/Xoff as flow control, it will be problem free.
Baud rate: 1200, 2400, 4800, 9600(default), 19200, 38400,
57600,115200 bauds. (Programmable by command)
Data format: always 8 data bits, 1 start bit and 1 stop bit.
Parity: always non parity
Handshaking:
If you run an application with the bundled printer driver under
Windows and use the serial port, you should check the above
parameters and set the flow control to "Xon/Xoff "or "hardware".
Terminal/Host
TxData
RxData
Ground
XON/XOFF as well as CTS/RTS (hardware flow
control).
123