Sending A Message - Panasonic KX-TG1850ALT Operating Instructions Manual

TG1850AL(e).book Page 36 Monday, December 6, 2004 9:10 PM
SMS (Short Message Service)
3
Select "Public", then press ,.
4
Select "Settings", then press ,.
5
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
30).
6
Select "Message Centre1" or
"Message Centre2", then press
,.
7
Edit the number as necessary, then
press , 2 times.
8
Press {ih}.
Note:
L If your phone is connected to a PBX, you
need to add the PBX line access number
and a dialling pause to the beginning of
the Message Centre 1 phone number.

Sending a message

Writing and sending a new
message
1
Press $ (middle soft key).
2
Select X, then press ,.
3
To access the public mailbox
Select "Public", then press ,.
To access a private mailbox
Select the desired mailbox, press ,,
then enter its password.
4
Select "Create", then press ,.
L If "^Use Last Text?" is displayed,
you can use the text from the last
message you created by pressing
{e}. This message will be displayed
only if the last message was created
using the same mailbox you selected
in step 3.
5
Enter the message (page 41), then
press ,.
6
Enter the destination phone number (20
digits max.), then press ,.
36
L To send the message to a party saved
in the phonebook, press U, select
the phonebook entry, then press ,
2 times.
L To send the message to a party logged
in the caller list, press {e} or {v}
repeatedly to select the party, then
press , 2 times.
L To send the message to a phone
number logged in the redial list, press
q repeatedly to select the phone
number, then press , 2 times.
L If you wish to send the message to the
other party's mailbox, enter the other
party's mailbox number after the
destination phone number.
Example: The other party's phone
number is 123456 and their mailbox
number is 1.
Enter 1234561.
If you do not enter the other party's
mailbox number, the message will be
sent to the public mailbox.
7
To save the message, select "Yes",
then press ,.
L To send the message without saving it,
select "No", then press ,.
8
To send the message, select "Send",
then press ,.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS
service provider. Consult your SMS
service provider for details.
L If your message contains over 160
characters, the message is a long
message and j is displayed. Your
service provider may treat long messages
differently from other messages. Consult
your service provider for details.