Table of Contents
Advertisement
Useful Information
Problem
I fully charged the batteries, but
7 still flashes.
I fully charged the batteries, but the
operating time seems to be short.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
I cannot register a handset to the
base unit.
28
Cause & solution
L Clean the charge contacts and charge again (page
8).
L It is time to replace the batteries (page 8).
L Wipe the battery ends (S, T) and the unit contacts
with a dry cloth.
L Your unit is connected to a telephone line with
ADSL (JetStream) service. We recommend that
you contact your ADSL service provider to have an
ADSL Splitter installed. We do not recommend the
use of generic ADSL filters. Contact your ADSL
service provider for details.
L Other telephone equipment such as a monitored
Burglar Alarm or the modem in the SKY Digital
decoder may be interfering with this unit.
Disconnect the other equipment and try again.
L Do not pause for over 1 minute while searching.
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 22).
L You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
L Place the handset and the base unit away from
other electrical appliances.
Advertisement
Table of Contents
