Table of Contents
Advertisement
Useful Information
Error messages
Error message
Memory Full
You must first subscribe
to Caller ID.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Telephone
Problem
w is flashing.
The handset display is blank.
The handset will not turn on.
I have changed the display
language to a language I cannot
read.
26
Cause & solution
L The handset's phonebook memory is full. Erase
unnecessary entries (page 13).
L You must subscribe to Caller ID service. Once you
receive caller information after subscribing to Caller
ID service, this message will not be displayed.
Cause & solution
L The handset is not registered to the base unit.
Register it (page 21).
L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources, such
as antennas and mobile phones.
L The handset is not turned on. Turn the power on
(page 9).
L Make sure that the batteries are installed correctly
(page 8).
L Fully charge the batteries (page 8).
L Clean the charge contacts and charge again (page
8).
L Change the display language (page 10).
Advertisement
Table of Contents
