After Use - Panasonic EW-DL83 Operating Instructions Manual

Misaligned teeth

After use

Cleaning the brush head and the main unit
1
Remove the brush head.
• Remove the brush head straight from the
toothbrush shaft.
2
Wash the brush head under
running water.
Wash the following parts thoroughly:
• Soiling on the inside and bottom areas of
the brush head
Observe caution regarding the following points:
• Do not pull the bristles of the brush
forcefully.
• Do not wash with water hotter than 80 °C.
Doing so may damage the brush head.
EW-DL83_EU.indb 15
Braces
• Apply the brush into the gap
between braces and teeth,
and then brush.
3
Wash the main unit under
running water.
• Do not damage or rub the
waterproof rubber seal (A) with
hard materials.
Do not leave the main unit under
water. Water may enter inside.
• Do not wash with water hotter than
40 °C.
Doing so may damage the main unit.
4
Wipe off water from the brush head and main
unit for storage.
Do not charge while it is wet.
Doing so may cause soiling.
If the identification ring comes off
As shown in the diagram at right, attach by
aligning the indentation in the brush head with
the raised part of the identification ring.
• Do not forcefully pull the identification ring.
Doing so may cause damage.
• Using the toothbrush without the identification
ring has no effect on its performance.
Cleaning the AC adaptor and the charging stand
Remove dirt with a cloth.
• Do not wash with water.

15
2015/12/14 14:30:39