Table of Contents
Advertisement
PREPARING THE REMOTE CONTROL UNIT
Remove the insulation sheet
Back of the Remote Control
"Replacing batteries" label
Precautions:
G Do not drop the remote control unit, subject it to hard shock or step on it (this might cause
breakage of parts and malfunction).
G Make sure there are no obstacles between the remote control unit and the remote-control
reception sensor on the monitor.
G Do not use the remote control unit at the same time as a remote control unit for other
devices.
G Replace the battery if the remote control unit no longer functions even when used close to
the monitor. For details, please refer to the label "Replacing the battery" on the back of the
remote control unit and to the instructions below.
Replacing the battery
If the remote control unit only works when held very close to the reception sensor, the battery is probably
exhausted.
In this case, please replace the battery with a new one.
1
Pull out the battery holder
Rear
2
Replace the battery
3
Reinsert the battery holder
Rear
Note:
6
the insulation sheet
Draw out the battery tray by sliding latch
direction of
Remove battery as shown below. Install the battery in the battery
Battery
tray. (Confirm that the positive pole marked "+" is facing up. )
(CR2025)
Replace the tray and slide back the latch until it snaps in place.
Also refer to the label ''Replacing the battery'' on the back of the remote control unit.
The lithium battery is included in the remote
control at the time of delivery.
Remove the insulation sheet to operate the
remove control.
as show below.
and pulling in the
Advertisement
Table of Contents
