Remote Control Batteries - Panasonic TH-42PW3 Operating Instructions Manual

I Remote Control Batteries
Requires two AA batteries.
1. Turn the transmitter face down.
Press and slide off the battery
cover.
2. Install the batteries as shown in
the battery compartment.
(Polarity + or - must match the
markings in the compartment).
3. Replace the cove and slide in
reverse until the lock snaps.
I
Helpful Hint:
For frequent remote control users, replace old batteries with
Alkaline batteries for longer life.
/_ Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
!. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline"),
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries,
5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display.
10