Remote Control Unit Preparation - Panasonic CY-VM5800U Operating Instructions Manual

u m (3 i
Remote Control Unit Preparation a
(Ly
G
Battery Installation (Inserting/Replacing the Batteries) | num battery È
4 Remove the battery holder (included) a
Puli the holder by the position B while pushing position Back side
A in the direction indicated by the arrow
2 Install the battery on the battery holder
Set a new battery properly with its (4-) side facing up as
shown in the figure
3 Insert the battery holder
Push in the battery holder back into its original position
Position B
Battery Notes
Remove and dispose of an old battery immediately
Battery Information
e Battery type Panasonic lithium battery (CR2025) (included)
e Battery life Approximately 6 months with normal use (at room temperature)
Battery holder Position À
Caution:
e Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire
Battery leakage may damage the unit
o Do not disassemble or short the battery Do not throw a battery into a fire
e Keep batteries away from children to avoid the risk of accidents
e Be careful to the local disposal rules when you dispose of batteries
Control Reference Guide
Point the remote control unit at the remote sensor
Power button (PUR) ———]1- (e) (te) Menu button (MENU)
(> page 12) (> page 13)
(ay
Aspect button (ASPECT) — A)
(= page 14) JE ON ob eis buttons (A, V)
Bright button (BRIGHT) QUE pages 13, 15, 16)
(> page 15) a
OM
Picture button (PICTURE) —)-(P)
(> page 16)
Enter button (ENTER)
(= pages 13, 16)
Ca M3838000 b
+%