Summary of Contents for Regency Fireplace Products Albany F200B-2
Page 1
Owners & Installation Albany F200B-2 Freestanding Wood Fire Model: F200B-2 PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information consult an authorised installer, service agency or the distributor.
Page 2
Thank-you for purchasing a REGENCY FIREPLACE PRODUCT. The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the REGENCY DEALER in your area.
SAFETY LABEL data badge NOTE: Regency units are constantly being improved. Check the label on This is a copy of the label that accompanies each F200B-2 Freestanding Wood Fire. We have printed a copy of the contents here for your review. the unit and if there is a difference, the label on the unit is the correct one.
installation RESIDENTIAL 10) Do not use grates or andirons or other methods even reduced heat output. Too tall a flue may prompt excessive draft which can result in for supporting fuel. Burn directly on the base or INSTALLATION very short burn times and excessive heat bricks where supplied.
installation MINIMUM CLEARANCE TO COMBUSTIBLE MATERIALS Hawkwind AHD Special Standard 400mm 400mm 100mm 100mm 75mm 125mm 100mm 100mm 96mm 96mm 350mm 350mm 880mm 880mm 932mm 932mm Floor Protection A combustible floor must be protected by non-combustible material (like tile, concrete board, or as defined by local codes) extending beneath the heater as follows;...
maintenance 3 SPEED OPERATING AIR SLIDE CONTROL FAN OPERATION INSTRUCTIONS Both the primary and air wash drafts are control- led by the control rod located on the right side A 3 speed fan is fitted to the heater. The fan is con- With your unit now correctly installed and safety of the unit (when facing the unit).
maintenance 6) During the first few fires, keep the combustion sages should not be altered to increase firing MAINTENANCE rate at a moderate level and avoid a large fire. for any reason. Only after 5 or 6 such fires can you operate the It is very important to carefully maintain your fire- heater at its maximum setting, and only after 17) If you burn the unit too slowly or at too low a set-...
maintenance Note : Thermodisc (temp. switch) in the fan control circuit. Heater/ Thermodisc must come up to operating temperature for fan to operate. See page 8 Regency Albany Freestanding Wood Fire...
parts list PARTS LIST PARTS LIST HEATER ASSEMBLY STOVE ASSEMBLY Part# Description 8010601 Top Plate/Panel 8010602 Panel Outer Side Right 8010603 Rear Panel 8010604 Panel Outer Side Left 1211700 Air Slide 8010616 Glass Neoceram With Gasket 8010612 Door Assembly (without Handle) 8010114 Door Handle Set 1141800...
Regency Fireplace Products and evaluated for manufacturer defect. The authorised selling dealer is responsible for all in-fi eld service work carried out on your Regency product. Regency Fireplace Products will not be liable for results or costs of workmanship from unauthorised service persons or dealers.
Page 15
WARRANTY warranty DISTRIBUTORS: Western Australia Eastern Australia New Zealand Fireplace Products Australia PTY. Ltd. Aber Holdings Air Group Australia 1-3 Conquest Way 17 Mainstreet Place 28-30 Division St. Welshpool, WA 6106 Hallam, VIC 3803 Te Rapa Ha. 3200 08 9350 2200 03 9799 7277 07 849 7585 NOTE: PLEASE RETAIN YOUR INVOICE AS PROOF OF PURCHASE FOR WARRANTY VERIFICATION...
Page 16
Register your Regency warranty online ® www.regency-fire.com.au Reasons to register your product online today! • View and modify a list of all your registered products. • Request automatic email notification of new product updates. • Stay informed about the current promotions, events, and special offers on related products.
Need help?
Do you have a question about the Albany F200B-2 and is the answer not in the manual?
Questions and answers