Sprite Quick Start Guide - MedeaWiz DV-S1 User Manual

.

Sprite Quick Start Guide

The MedeaWiz® Sprite ships with the Video Output set to HDMI at 720p and the Control Mode
set to "Trigger Low No Interrupt" Mode to use a pushbutton trigger.
Most users can simply connect their HDMI monitor and install their SD memory card, with files
named in the same way as the earlier model MedeaWiz players.
Example 1: You have one file that you need to run in a loop when power is turned on:
Name the file 000.xxx (where xxx is the proper file extension such as mpg, wmv, mp4, mt2s or
etc.)
Example 2: You have a looping file and also want to use the Trigger with a push button:
Name the looping file 000.xxx as above. Then name the trigger file 001.xxx
Example 3: You have a looping file and also want to use the Serial Port control:
Name the looping file 000.xxx as above. Then name the other files 001.xxx, 002.xxx, 003.xxx and
etc. in order.
Using the IR remote control, go into the on screen menu and set the Control Mode to Serial
Control, and set the Baud Rate to match your external controller.
You should always have a 000.xxx looping file if using the trigger input or serial control.
It can be a black file if no video is wanted until a trigger or command. We suggest the looping
file be at least 30 seconds long.
Make sure you are using ZEROS and not the letter O in the file name. Do not put the files in a
folder. Only put media files on the SD card.
You can download HD test files at
video-clips/6537-official-hd-video-clip-list.html
http://www.highdefforum.com/high-definition-movies-
MedeaWiz® Sprite
4 | P a g e