Gdm & T-Series Idlglass Insert Replacement - True GDM Series Technical & Service Manual

GDM & T SERIES IDL GLASS INSERT REPLACEMENT
Warning:
The Edges on the glass
insert are very sharp. To
avoid personal injury, u s e
adequate protection for your
eyes and hands when working
or handling this or any
other glass component.
Required tools:
- Phillips head screwdriver
- 3/8" Wide double sided tape
- Side cutters (if working with
freezers)
- Butt connectors (if working
with freezers)
- Crimping tool (if working with
freezers)
__________ STEP 1 __________
Disconnect power to the cabinet.
__________ STEP 2 __________
Disconnect IDL plug from cooler.
__________ STEP 3 __________
Loosen up the tension from torsion
spring and remove door. Refer to
Removal and Installation of GDM
and T-Series Swing
Instructions on page 46-47.
__________ STEP 4 __________
Remove doors handle and place
door on a flat surface.
__________ STEP 5 __________
Remove door gasket and back
plates from the top, bottom and
handle side.
__________ STEP 6 __________
Beginning at the upper corner in the
handle side, carefully pry the bro-
ken glass loose. If necessary, use a
heat gun or hair dryer to loosen up
the insert from double sided tape.
Do not forget to disconnect the
glass insert heater wires before
pulling it out and reconnect
them before sliding the new
glass insert in.
__________ STEP 7 __________
Remove any excess tape and glass
from the lip on the door's frame and
replace with new double sided tape.
Door
Note:
66
__________ STEP 8 __________
Install the new glass insert by push-
ing it into the light channel first and
then work out-wards toward the
handle side.
NOTE:
Make sure the TRUE logo on the
insert, is located outside at the
bottom of the frame.
__________ STEP 9 __________
Install gasket back plates and gasket.
__________STEP 10 __________
Mount door and tighten torsion
spring. Refer to Removal and
Installation of GDM and T-Series
Swing Door Instructions on page
46-47.