Configuring The 510 Sensor; Connect To 510 Sensor; Access The Sensor Ui - Motorola AirDefense Model 510 Installation Manual

24 Model 510 Sensor: Installation Guide
5

Configuring the 510 Sensor

5.1 Connect to 510 Sensor

1. Directly connect the Sensor to your station using the supplied Ethernet cable.
2. Power up the Sensor with your 802.3af compliant PoE source.

5.2 Access the Sensor UI

You will be using the Sensor User Interface (UI) for this setup, an HTML-based interface that resides
on the Sensor. Use the Sensor UI to initially configure Sensors, and to perform some maintenance
activities after the initial installation. For a detailed description on the Sensor UI,
page -27.
To access the Sensor UI, you must log in remotely from your workstation web browser.
1. Set your workstation's IP address to
2. Type
https://192.168.100.100
The Sensor UI login screen appears.
3. Enter the default user name and password in the login screen:
User Name:
Important!
NOTE If an AirDefense PoE injector is used, connect your Station to
"Data In" and connect your Sensor to "Data and Power out".
in your browser; press
, Password:
admin airsensor
In the interest of security, change the Sensor Web User login password at
your earliest opportunity.
and subnet mask to
192.168.100.10
.
Enter
see "Sensor UI" on
.
255.255.255.0