Table of Contents
Advertisement
Setting
Use DHCP
Obtain DNS Automatically
New Admin Password/
Verify Admin Password
New Monitor Password/
Verify Monitor Password
After you enter or change configuration information on the Configure Sensor tab, use the buttons
along the bottom of the screen to:
•
—discards changes.
Cancel
•
Save Basic Settings
The following screen shows the confirmation you see after your changes are saved and the sensor is
about to reboot.
Select the option of setting up your Sensor to use DHCP. It
is enabled by default. If you do not want to use DHCP,
choose
, and then type the sensor's:
No
•
IP Address
•
Netmask
•
Gateway IP Address.
Automatically obtaining DNS is disabled by default. If you
want to automatically obtain DNS, select the
not, leave the
No
following:
•
Primary DNS
•
Secondary DNS
•
Domain Name.
To change the password for an admin user, type the new
password, and then verify it by typing it again.
To change the password for a monitor user, type the new
password, and then verify it by typing it again.
—applies changes and saves them on the AirDefense server.
Description
button selected, and then type the
Sensor UI
29
button. If
Yes
Hide quick links:
Advertisement
Table of Contents
