Multiple Monitor Connection - Panasonic WV-CM1420 Operating Instructions Manual

Multiple Monitor Connection

To monitor the same video on multiple monitors, connect
the VIDEO OUT A or B connector on the monitor to the
VIDEO IN connector of the other monitor with a coaxial
cable.
Up to 10 monitors in total can be connected in series
before signal loss occurs. Total cable length should not
exceed 150 meters (500 feet).
Connection to the Standby
On/Off Terminal
Connecting an outboard device to the STANDBY ON/OFF
Terminal on the rear of the monitor enables control of the
monitor display by input from that device, both in normal
and standby display mode.
Shown below is an example of how to use this function.
STANDBY
ON
STANDBY
OFF
G
Alarm Output
Alarm Reset Output
• STANDBY ON input
Pulse +5 V DC
• STANDBY OFF input
Non-voltage contact or open collector output
Note: To set up this function, refer to STANDBY ON in
the Display Setting menu.
7
Hi-Z
V 0.2 V
L
V 5 V
H
V 0.2 V
L