Table of Contents
Advertisement
5-6
Instruments and Controls
note pad holder, or any other
magnetic item. Turn off the vehicle,
move the magnetic item, then turn
on the vehicle and calibrate the
compass.
To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone is
set to the variance zone in which
the vehicle is located. See
Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, climate
controls, seats, etc. during the
calibration procedure.
2. Press
until PRESS
CALIBRATE COMPASS
displays.
3. Press
to start the compass
calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle in
tight circles at less than 8 km/h
(5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE
for a few seconds when the
calibration is complete. The DIC
display will then return to
PRESS
COMPASS.
Clock
AM/FM Radio with Optional CD
Player
If the vehicle has an AM/FM radio
with an optional CD player, it has a
TO
button for setting the time. With
these types of radios, the clock can
be set with either the radio turned
on or off.
TO CALIBRATE
Set the time by following these
steps:
1. Press
until the hour begins
flashing on display. Press this
button a second time and the
minutes begin flashing on
display.
Press
a third time and the
12HR or 24HR time format
begins flashing.
2. While either the hour or the
minutes are flashing, turn the
knob, located on the upper right
side of the radio, clockwise or
counterclockwise to increase or
decrease the time. While the
12HR or 24HR time format is
flashing, turn the
knob
clockwise or counterclockwise to
select the default time settings.
3. Press
again until the clock
display stops flashing to set the
currently displayed time;
otherwise, the flashing stops
Advertisement
Chapters
Table of Contents
