How To Attach The Rack Mounting; Error/Warning Displays; Maintenance - Panasonic BT-LH1700WE Operating Instructions Manual

How to Attach the Rack mounting

If you use rack-mounting adaptors BT-MA1710G (optional) with this monitor, you can incorporate a 19-inch
standard rack (the height is 7U size). Please see the instructions below for attachment.
1. Remove the screws on the back and base of the
monitor (3 places), and remove the stand.
Rear view
Screw
Base

Error/Warning Displays

If for any reason an error occurs in this monitor, the LEDs above the picture adjusting knob flash at 1-second
intervals (informing you of the error/warning display).
Error/Warning
displays
Inverter error
If a malfunction occurs in the inverter that
controls the backlight brightness, the
backlight will switch OFF.
The screen becomes completely black.
Fan stop
The fan in the back of the monitor stops if
Error
a malfunction occurs. If a picture is being
displayed when the malfunction occurs, it
will continue being displayed as is.

Maintenance

• To clean the cabinet or surface of the liquid crystal protection panel, gently wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a weak detergent solution and then wrung-out to
clean the surfaces, then use a dry cloth to finish. Water or similar substances getting inside the monitor can
cause a malfunction.
• Never use thinner or benzene to clean this unit.
Doing so would cause the surface of the monitor to become discolored, and cause paint to peel.
• Do not spray cleansers directly onto the monitor.
Water or similar substances getting inside the monitor can cause a malfunction.
2. Using the screws provided, attach the rack-
mounting adaptors to both sides of the monitor.
Stand
Screw
Symptom
Rack-mounting adaptor
Solution
Switch the power supply OFF once, then
switch it back ON again. If an error is still
displayed, contact the vendor where you
purchased the monitor.
If the error is still displayed after this,
contact the vendor where you purchased
the monitor immediately.
If a fan stop error occurs, setting "FAN
MOTOR" to "OFF" in the "SYSTEM
CONFIG" menu (refer to page E-17)
allows you to continue using the monitor
with reduced screen brightness.
E-26