Table of Contents
Advertisement
Using video select with AV2 input
1. Enter the service mode.
[
Service mode: While power is off, press [Pause], [Open/Close] and [Stop] keys
simultaneously.]
2. Set [DVD/TV] switch on remote controller to DVD.
3. Input Video signal ( Video,Y/C and RGB ) to AV2 in.
4. When the channel key [8][1] is pressed, video signal should output on AV1 (Video).
5. When the channel key [8][2] is pressed, video signal should output on AV1 (Y/C).
6. When the channel key [8][3] is pressed, video signal should output on AV1 (RGB).
Using P50 ( Q-Link ) control
1. Enter the service mode.
[
Service mode: While power is off, press [Pause], [Open/Close] and [Stop] keys
simultaneously.]
2. Set [DVD/TV] switch on remote controller to DVD.
3. When the channel key [8][4] is pressed, 10pin of AV1 will be about 5V.
4. When the channel key [8][5] is pressed, 10pin of AV1 will be about 0V.
2. Separation of REC, PLAY and EE systems
Check PLAY system and REC system circuits in EE2 mode.
(EE2 mode: L1 input signal passes the same circuit as REC system and PLAY system
except for RAM drive.)
1. Enter the service mode.
[
Service mode: While power is off, press [Pause], [Open/Close] and [Stop] keys
simultaneously.]
2. Set [DVD/TV] switch on remote controller to DVD.
Advertisement
Table of Contents
