Maintenance - Makita 906H Instruction Manual

MAINTENANCE
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
.
CAUTION:
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down to
the limit mark. Keep the carbon brushes
clean and free t o slip in the holders. Both
carbon brushes should be replaced a t the
same time. Use only Makita carbon brushes.
Use a screwdriver t o remove the brush
holder caps. Take out the worn carbon
brushes, insert the new ones and secure the
brush holder caps.
Limit
mark
Brush holder cap
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.