Makita 906H Instruction Manual page 7

Operation
Turn the tool on without the wheel point
making any contact with the workpiece
and wait until the wheel point attains full
speed. Then apply the wheel point to the
workpiece gently.
To
obtain a good finish,
move the tool in the leftward direction
slowly.
CAUTION :
Apply light I:
sure
on
the
DO(.
Excessive pressure on the tool will only cause a poor
finish and overloading of the motor.
Dressing wheel point
When the wheel point becomes "loaded"
with various bits and particles, you should
dress the wheel point with the dressing
stone.
7