Preparation After Storage - Arctic Cat XC 450 Operator's Manual

Preparation after Storage

Taking the ATV out of storage and correctly preparing it will assure
many miles and hours of trouble-free riding. Arctic Cat recommends
the following procedure to prepare the ATV.
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the cloth from the exhaust system.
3. Check all control wires and cables for signs of wear or fraying.
Replace if necessary.
4. Change the engine/transmission oil and filter.
5. Check the coolant level and add properly mixed coolant as neces-
sary.
6. Charge the battery; then install. Connect the battery cables mak-
ing sure to connect the positive cable first.
58
CAUTION
Before installing the battery, make sure the ignition switch is
in the OFF position.
7. Check the entire brake systems (fluid level, pads, etc.), all con-
trols, headlights, taillight, brakelight, and headlight aim; adjust or
replace if necessary.
8. Check the tire pressure. Inflate to recommended pressure as nec-
essary.
9. Tighten all nuts, bolts, cap screws, and screws making sure all
calibrated nuts, cap screws, and bolts are tightened to specifica-
tions.
10. Make sure the steering moves freely and does not bind.
11. Check the spark plug. Clean or replace as necessary.
12. Check the air filter and the air filter housing. Clean or replace as
necessary.