Makita DHP480 Technical Information page 10

W
iring diagram
Fig. D-3
Wiring in upper space of Switch
Put the slack portion of Lead wires
of Stator and those of Controller
for connecting to LED light circuit
in this space while paying attention
not to put any lead wires onto the ribs.
Printed wiring board
Rib E
Be careful not to put Lead wires
onto Ribs E, F, G and H when
guiding them in the space
between Switch and Stator.
Insulated connector (3 pcs.)
Be careful not to put Connecting
terminals under or on Capacitor.
Rib of Controller
Wiring of Lead wires connecting Terminal and Controller
Wiring in Housing L
Stator
Rib F
Rib G
Rib H
Put Lead wires connecting
Controller
Terminal and Controller
between (Controller's) Rib
and Housing L.
Rib of
Controller
Terminal
Housing L
Rib A Rib B Rib C
Put the slack portion of Lead wires
of Printed wiring board to the space
keeping the distance from the tip
of Rib A toward LED side.
Switch
Controller
Controller
Terminal
P 10/ 12
Put connector
to this space.
LED light
circuit
Rib D
Put the following Lead wires
under the other Lead wires.
* Lead wire (red) of
Terminal
* Lead wire (white) of
Controller
Put the following Lead wires
into this groove.
* Stator's lead wires (3 pcs.)
* Lead wires of Printed
wiring board
* Lead wires for connecting
to LED
Do not put any Lead wires
onto these Ribs.
Capacitor
(integral part of Controller)
When checking Controller,
do the test according to
"Test for recognizing
the trouble on Controller"
at last page.