User Interface; Quick Installation; Menu Operations - DGTEC DG-SD3401 User Manual

User Interface

1.Quick Installation

1.1 Setting Country and Language
User can select preferred country and language at Setup - Installation
page.
(1) Press <Menu> button to enter Main Menu.
(2) Press <Left/Right> button to select SETUP option.
(3) Press <Up/Down> button to select Installation option.
(4) Press <OK> button to enter Installation page.
(5) Press <Up/Down> button to select Country option.
(6) Press <Left/Right> button to set Country Setting.
(7) Press <Up/Down> button to select OSD Language option.
(8) Press <Left/Right> button to set a language.
If there is no channel database in the STB, it will start at step(5) directly
when booting.
1.2 How to receive the programs?
Scan the possible frequency and bandwidth to receive the programs.
Press <RED> or <GREEN> button to start Auto Scan or Manual Scan.
1.2.1 Auto Scan
Auto Scan will erase the database first, and scans default frequency
and bandwidth by Country Setting. Follow the steps (1) ~ (8) at
section 1.1.
(9) Press <RED> button to clear the database.
(10) Press <OK> button to confirm, clear action and start Auto Scan .
It takes time to do a Auto Scan, user can press <Exit> button to exit at
anytime. See Figure 1. Later if you want to scan again, you can follow
above the Quick Installation procedure.
SETUP. Installation 01/01/2008 00:19
Antenna_Setting OFF
Country Setting England
OSD Language English
Database will be cleared! Continue?
Audio Language
OK YES Exit OFF
Subtitle Language English
LCN
ON
Move Switch Exit
Auto Scan Manual Scan
Figure 1. Clear database message Figure 2. Manual Scan edit
1.2.2 Manual Scan
Manual Scan adds the scanning results into database, it doesn't erase
the database. The User has to know the Frequency and Bandwidth
for scanning. If the user scans the same Frequency and Bandwidth
more than once, the previous programs will be overwritten.
( 9 ) Press <GREEN> button to enter Manual Scan Page.
(10) Press <Up/Down> button to select Frequency option.
(11) Press <0~9> button to input the Frequency value.
(12) Press <Up/Down> button to select Bandwidth option.
(13) Press <Left/Right> button to set Bandwidth value.
(14) Press <OK/Exit> button to start scan or exit.
See Figure 2.

2.Menu Operations

Once the channel scan is finished and all the channels are stored into
the database, you can start to watch a digital terrestrial TV channel
or listen to the radio broadcast. Some typical operations are given in
this chapter.
2.1 Main Menu
Main Menu for operating a lot of functions.
(1) Press <Menu> button to enter Main Menu.
(2) Press <Info> button to display the version information of STB.
2.2 SETUP
Set the system settings of STB.
2.2.1 Installation
Sets up the channels by automatically searching for networks
2.2.1.1 Antenna Setting
MANUAL SCAN 01/01/2008 02:19
Set the antenna power on or off to supply +5V power to antenna
Channel No. CH .21
Frequency 474.000 Mhz
Bandwidth
8 Hz
Strength 65 %
Quality 94 %
Move Move OK Scan Exit
Edit
3