BMW C600Sport Rider's Manual page 36

Tyre pressure, both
3
tyres, outside permitted
tolerance
34
with tyre pressure monitoring
OE
(RDC)
General warning light
flashes red.
Tyre symbol with arrows
pointing up and down ap-
pears on the display.
The tyre pressure readings flash.
Possible cause:
Measured tyre pressure in both
z
tyres is outside permitted toler-
ance.
Check the tyre for damage
and to ascertain whether the
vehicle can be ridden with the
tyre in its present condition.
If the vehicle can be ridden with
the tyres in the present condition:
Incorrect tyre pressures im-
pair the Scooter's handling
characteristics.
If tyre pressure is incorrect it is
essential to adapt your style of
riding accordingly.
Correct the tyre pressure at the
earliest possible opportunity.
Before you adjust tyre pres-
sure, read the information
on temperature compensation
and adjusting pressure in the
section entitled "Engineering
details".
Have the tyre checked for
damage by a specialist
workshop, preferably an
authorised BMW Motorrad
dealer.
If you are unsure whether the
vehicle can be ridden with the
tyres in the present condition:
Do not continue your journey.
Notify the breakdown service.
Signal transmission
disrupted
with tyre pressure monitoring
OE
(RDC)
­­ ­­:­­
" " or " " is displayed.
Possible cause:
The vehicle has not yet accel-
erated past the threshold of ap-
proximately 30 km/h. The RDC
sensors do not start transmitting
signals until the vehicle reaches
a speed above this threshold for
the first time ( 76).
Increase speed above this
threshold and observe the RDC
readings. Assume that a per-
manent fault has not occurred
unless the 'General' warning
light comes on to accompany
the symptoms. Under these
circumstances:
Have the fault rectified by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.