Battery; Maintenance Instructions - BMW C600Sport Rider's Manual

attempt in order to protect the
starter motor and the donor

battery.

Allow both engines to idle for a
few minutes before disconnect-
ing the jump leads.
Disconnect the jump lead from
the negative terminal and the
ground point first, then dis-
connect the second jump lead
from the positive terminal and
the battery connection point.
Do not use proprietary
start-assist sprays or other
products to start the engine.
Install the side panel (

Battery

Maintenance instructions

Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential if
warranty claims are to be con-
sidered.
Compliance with the points be-
low is important in order to max-
imise battery life:
Keep the surface of the battery
clean and dry
Be sure to read and comply
with the instructions for char-
ging the battery on the follow-
ing pages
Do not turn the battery upside
down
If the battery is not discon-
nected, the on-board elec-
tronics (e.g. clock, etc.) gradually
drain the battery. This can cause
114).
the battery to run flat. If this hap-
pens, warranty claims will not be
accepted.
Connect a float charger to the
battery if the motorcycle is to
remain out of use for more than
four weeks.
Charging battery when
connected
Charging the connected
battery directly at the bat-
tery terminals can damage the
vehicle electronics.
Always disconnect the battery
from the on-board circuits be-
fore recharging it with a charger
connected directly to the battery
posts.
If you switch on the igni-
tion and the multifunction
display and indicator lights fail
to light up, the battery is com-
pletely flat (battery voltage is less
than 9 V). Attempting to charge
a completely flat battery via the
extra socket can cause damage
to the motorcycle's electronics.
If a battery has discharged to the
extent that it is completely flat, it
has to be disconnected from the
on-board circuits and charged
9
111
z