Connecting To A Tv And Vcr Both Fitted With Scart Sockets - Philips DTR2000 Owner's Manual

- Plug all your equipment, excluding your digital receiver, into the mains.
- Switch on your TV and select a channel.
- Plug your digital receiver into the mains.Your digital receiver will display the "WELCOME" screen
(the left-hand LED will be illuminated green).
- Go to Quick installation to proceed with the channel scan of your digital receiver.
If the "WELCOME" screen is not displayed, press the TV/STB button two times to get the screen
displayed.
Note: With this connection set up you can:
- Watch digital terrestrial TV through your digital receiver.
- Continue watching analogue TV as normal.
5.2

Connecting to a TV and VCR both fitted with SCART sockets

Incorporate your receiver in your existing installation as shown below.
- Plug your aerial lead plug into the "AERIAL IN" socket of your digital receiver.
- Connect the "RF OUT" socket of your digital receiver to the "Aerial input" socket of your VCR
using the RF coaxial lead supplied with your digital receiver.
- Connect the "RF OUT" socket of your VCR to the "Aerial input" socket of your TV using a RF
coaxial lead.
- Connect the "TV" SCART socket of your digital receiver to the "EXT1" SCART socket of your TV
using the SCART lead supplied with your digital receiver.
- Connect the "VCR" SCART socket of your digital receiver to the RGB-capable "EXT1" SCART
socket of your VCR using a SCART lead.
- Plug all your equipment, excluding your digital receiver, into the mains.
- Switch on your TV and select a channel.
14 CONNECTING YOUR DIGITAL RECEIVER