Mac Acls; Configuring Acls - Cisco WAP551 Administration Manual

Client Quality of Service
ACL
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point

MAC ACLs

MAC ACLs
MAC ACLs are Layer 2 ACLs. You can configure the rules to inspect fields of a frame such as
the source or destination MAC address, the VLAN ID, or the class of service. When a frame
enters or exits the WAP device port (depending on whether the ACL is applied in the up or
down direction), the WAP device inspects the frame and checks the ACL rules against the
content of the frame. If any of the rules match the content, a permit or deny action is taken on
the frame.

Configuring ACLs

Configuring ACLs
Configure ACLs and rules on the ACL Configuration page, and then apply the rules to a
specified VAP.
These steps give a general description of how to configure ACLs:
Select Client QoS > ACL in the navigation pane.
Specify a name for the ACL.
Select the type of ACL to add.
Add the ACL.
Add new rules to the ACL.
Configure the match criteria for the rules.
Use the Client QoS Association
These steps give a detailed description of how to configure ACLs:
page to apply the ACL to one or more VAPs.
7
115