At The End Of The Program; When The Washing Program Is Completed, But There Is Water In The Drum; Auto Off Mode - Electrolux EWF14023 User Manual

If the door lock indicator "
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of emergency please
refer to "Emergency door
opening" on page 27.

5.9 At The End Of The Program

-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show "
-
The indicator of the touchpad
Start/Pause goes off.
-
The door lock indicator "
-
Remove the laundry from the
appliance. Make sure that the drum is
empty.
-
Keep the door partly open, to prevent
the mildew and odours.
-
Turn off the water tap.
At the end of the program, the time
remaining can suddenly decrease
from 7 minutes or less to 0 due to the
overestimated total program time
during the load sensing phase. In
some cases (with perfectly balanced
load) the program time can be shorter
than the time estimated after the load
sensing phase is completed. This is a
normal behavior of the machine and
not a cause for concern as it does not
compromise its performance.
5.10
When The Washing
Program Is Completed, But
There Is Water In The Drum
(Option "Rinse Hold" or "Extra
Silent" is used)
-
The drum turns regularly to prevent
the creases in the laundry.
-
The indicator "Start/Pause" flashes to
remind you to drain the water.
-
The door lock indicator "
The door stays locked.
" does not You must drain the water to open the
door.
To drain the water:
Press the "Start/Pause
1.
The appliance drains the water and
spins with the maximum spin speed
for selected program.
Alternatively, before pressing the
"Start/Pause" touchpad, you can press
the "Spin
spin speed. You can select "No Spin",
if you want the machine to only drain
the water.
When the program is completed and
2.
the door lock indicator "
".
you can open the door.
Press the "On/Off" button to deactivate
3.
the appliance.
" goes off.
After approximately 18 hours, if you do
not press Start/Pause touchpad, the
appliance will drain and spin automati-
cally (except for "Wool" program) .
5.11
The AUTO Off mode automatically
deactivates the appliance to decrease
the energy consumption when:
You do not press any buttons for 5
minutes before you press
"Start/Pause".
After 5 minutes from the end of the
washing program.
-
-
-
" is on.
" touchpad to change the
NOTE:

AUTO Off Mode

Press the "On/Off" button to
activate the appliance again.
Press the "On/Off" button to
reactivate the appliance. Display will
show the end of the last wash.
Press any touchpad again to show
the last wash program.
Touch the program touchpad to set a
new wash program.
ENGLISH 17
" touchpad.
" goes off,