handle of the stand back until
both rollers of the stand are on
the ground.
Then press the handle down to
the ground.
In order to ensure secure pos-
itioning, fit lever 4 to the short
side of the stand.
Lighting
Replacing bulbs for low-
beam headlight and high-
beam headlight
The plug arrangement can
differ from the illustration,
depending on the bulb to be
replaced.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove cover 1 for the high-
beam headlight or cover 2 for
the low-beam headlight, as ap-
plicable, by turning the cover
counter-clockwise.
Disconnect plug 3.
Disengage spring clip 4 from
the latches and swing it up.
9
115
z