Connections - Panasonic TH-37PR11UK Operating Instructions Manual

Connections

– AC cord fi xing
Note:
Make sure that the AC cord is locked
on both the left and right sides.
– Cable fi xing band
Secure any excess cables with band as required.
Note:
One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
1
SLOT1
1
Plug the AC cord into
1
the display unit.
Plug the AC cord until
it clicks.
2
2 Fix the AC cord with
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten:
Pull
2
SLOT2
Optional Terminal
Board Insert Slot
(covered)
AC cord connection (see page 12)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob
pressed.
To loosen:
Push the catch
SLOT3
From EXTERNAL
monitor terminal on
Computer (see page 10)
Unplug the AC cord
Unplug the AC cord pressing
the two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet fi rst.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on Computer
(see page 11)
9