Adjusting Pos. /Size - Panasonic TH-37PR11UK Operating Instructions Manual

Adjusting POS. /SIZE

1
2
3
4
Notes:
• Unadjustable items are grayed out.
Adjustable items differ depending on the input signal and the display mode.
• Adjustment details are memorized separately for different input signal formats. (Adjustments for component signals are
memorized for 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 1125 (1080) / 60i · 50i · 60p · 50p · 24p · 25p · 30p · 24sF,
1250 (1080) / 50i, 750 (720) / 60p · 50p each, and RGB/PC/Digital signals are memorized for each frequency.)
• If a "Cue" or "Rew" signal from a VCR or DVD player is received, the picture position will shift up or down. This picture
position movement cannot be controlled by the POS. /SIZE function.
• If adjusting the PICTURE V-POS / V-SIZE in Panasonic AUTO with FULL mode, the adjustment is not memorized. When
exiting the mode, the screen will return to a former adjustment.
AUTO Automatically adjust H-POS / V-POS / CLOCK PHASE / DOT CLOCK and set H-SIZE / V-SIZE the standard
SETUP value when RGB signal is input.
Notes:
• If the dot clock frequency is 108 MHz or higher, DOT CLOCK cannot be made.
• If the image is that the edge is hardly fi gured out or shadowy, that cannot be adjusted automatically.
In such case, press AUTO SETUP again after changing the image to the clearer one.
• When DVI-D is input, CLOCK PHASE cannot be adjusted automatically.
• Select NORMALIZE in POS. /SIZE and press the ACTION ( ) button when appropriate adjustment cannot
be made.
H-POS Adjust the horizontal position.
H-SIZE Adjust the horizontal size.
DOT (During "COMPONENT", "RGB" and "PC" input signal)
CLOCK Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
adjust so that any such noise is minimized.
CLOCK (During "COMPONENT", "RGB" and "PC" input signal)
PHASE Eliminate the fl ickering and distortion.
Helpful Hint (
While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION
( ) button is pressed during "NORMALIZE", then all adjustment values are returned to the factory settings.
Press to display the POS. /SIZE menu.
Press to select the menu to adjust.
Press to adjust the menu.
Press to exit from adjust mode.
/ Normalization)
NORMALIZE
V-POS Adjust the vertical position.
V-SIZE Adjust the vertical size.
During "VIDEO (S VIDEO)", "Digital",
"SDI" and "HDMI" input signal.
POS. /SIZE
NORMALIZE
NORMAL
AUTO SETUP
0
H-POS
0
H-SIZE
0
V-POS
0
V-SIZE
During "COMPONENT", "RGB"
and "PC" input signal.
POS. /SIZE
NORMALIZE NORMAL
AUTO SETUP
0
H-POS
0
H-SIZE
0
V-POS
0
V-SIZE
0
DOT CLOCK
0
CLOCK PHASE
21