Using The Doug Hall Rbi-1 Remote Base Interface; Remote Base Power Select; Memory Select - Arcom RC-210 Operation And Programming Manual

A73x Mode select. x equals:
1 = LSB
2 = USB
3 = CW
4 = FM
5 = AM
A75x Recall Remote Base Memories 1 to 10 (this command only affects NON-DOUG HALL supported radios)

Using the Doug Hall RBI-1 Remote Base Interface

There are extra remote base commands available for use if you have selected the Doug Hall RBI-1 for use as your remote base.
these only work if "5" is selected as your remote base radio type
User Function Outputs
The RBI-1 provides 7 User Function outputs that can be used (in addition to Logic Outputs of the RC-210) to control hardware at the
repeater site. Refer to the Doug Hall manual for details on making connections.
A74 x y User Outputs 1 through 7, where "x" is the output and "y" = 1 ON, 2 OFF

Remote Base Power Select

A75 x Select Transmitter power of the connect remote base radio, where x
0
1
2
3

Memory Select

The Doug Hall RBI-1 provides for memory recall of up to 20 memories within the controlled radio
A76x Select Memory 1 - 20
capable of multimode use.
Note: Any port used for a remote base should be defined as half-duplex.
Low Power
High Power
Medium Power
Don't change
Note: This command only has relevance if you're using a remote base radio
12
Note: