Require/Not Require Ctcss For Dtmf; Auxiliary Audio Inputs; General Logic Outputs; Extended Logic Outputs - Arcom RC-210 Operation And Programming Manual

Require/Not Require CTCSS for DTMF

Each port may be configured to either require a user's signal to contain CTCSS or not require it, in order to enter DTMF commands.
This selection controls DTMF access regardless of the state of the access required for repeater access on that port. In other words, it is
possible to have a port configured for carrier squelch access, yet require CTCSS for DTMF commands to work.
1170 Port 1 no CTCSS for DTMF*
1171 Port 1 CTCSS for DTMF

Auxiliary Audio Inputs

These inputs can be used for connecting external audio devices, such as a weather receiver. When turned on, the selected transmitter
is locked on for a period selected by a programmable timer. After this timer times out, the audio is disconnected and the transmitter is
unkeyed. Which port a particular input is routed to is determined by programming commands.
1961 Turn Auxiliary Audio Input 1 ON
1960 Turn Auxiliary Audio Input 1 OFF
1971 Turn Auxiliary Audio Input 2 ON
1970 Turn Auxiliary Audio Input 2 OFF

General Logic Outputs

There are 7 switched outputs that can be commanded on or off. They can also be pulsed ( 0.1 ms low, 0.1 ms open, 0.1 ms low). When
an output is high, it is actually an open collector. If you need a logic high present, you can provide a pull up resistor (up to 100 vdc).
1810 Logic Output 1 Open Collector
1811 Logic Output 1 Low
1812 Logic Output 1 Pulsed (low, open, low)
1820 Logic Output 2 Open Collector
1821 Logic Output 2 Low
1822 Logic Output 2 Pulsed (low, open, low)
1830 Logic Output 3 Open Collector
1831 Logic Output 3 Low
1832 Logic Output 3 Pulsed (low, open, low)
1840 Logic Output 4 Open Collector
1841 Logic Output 4 Low
1842 Logic Output 4 Pulsed (low, open, low)
Note: These outputs are independent of the "Output Sinker" functions provided by the Doug Hall RBI-1 Remote Base Interface, which work in
addition to the Logic Outputs above. See the Remote Base section of this manual for details.

Extended Logic Outputs

If you have connected external shift registers as explained in the Hardware Reference section of this manual, you have a total of 64
logic outputs available to you.
1810xxy Logic Output xx (1-64) to state y
y = 0 Logic low
y = 1 Logic High
y = 2 Pulsed output (low, open, low)
2170 Port 2 no CTCSS for DTMF*
2171 Port 2 CTCSS for DTMF
1981
1980
1850 Logic Output 5 Open Collector
1851 Logic Output 5 Low
1852 Logic Output 5 Pulsed (low, open, low)
1860 Logic Output 6 Open Collector
1861 Logic Output 6 Low
1862 Logic Output 6 Pulsed (low, open, low)
1870 Logic Output 7 Open Collector
1871 Logic Output 7 Low
1872 Logic Output 7 Pulsed (low, open, low)
10
3170
3171
Turn Auxiliary Audio Input 3 ON
Turn Auxiliary Audio Input 3 OFF
Port 3 no CTCSS for DTMF*
Port 3 CTCSS for DTMF