Table of Contents
Advertisement
Information on the display panel
Display
Pause: Reload is not
possible
Door cannot be
unlocked: Water level
or temperature is too
high
The door cannot be
locked; please open
the door again, then
close it and select the
A button
Turn on the tap
Clean the drain pump
AquaStop has been
activated. Please call
the after-sales service
Auto power-off in ...
seconds,
Water cooling
Drum care
information:
}
|
Other displays
Error E:XXX
Cause/remedy
Temperature or water level is too high. Press the A button to continue the
programme.
Temperature or water level is too high. Press the A button to continue the
programme.
Laundry may be caught. Open and close the door again and press the A
■
button.
If necessary, push the door closed or remove some laundry and then push it
■
closed again.
If necessary, switch the appliance off and on again; set the programme and
■
make your individual settings; start the programme.
Turn the tap on fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter. ~ Page 59
■
The drain pump is blocked. Clean the drain pump. ~ Page 58
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 59
Not applicable on models without AquaStop
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
Appliance automatically switches off after ... seconds if it is not operated for a
prolonged period. To cancel, press any button. ~ Page 55
To protect the wastewater pipes, the hot detergent solution is cooled before being
drained.
This instruction reminds you to run the Drum Clean 90 °C programme or a 60 °C
programme to clean and care for the drum and the outer tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent that contains bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
Switch reminder information on/off. ~ Page 55
■
Remote start selected. ~ Page 49
Off: Wi-Fi is switched off and the appliance is not connected to your home network.
Flashing: The appliance is trying to connect to your home network.
Lit: Wi-Fi is switched on and the appliance is connected to your home network.
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call the after-sales service.
Faults and what to do about them.
en
61
Advertisement
Table of Contents
