Table of Contents
Advertisement
G Installation
1. Open the dome cover. (See Disassembling the
camera.)
2. Place the heater unit in the camera and fix it with
the supplied screw.
3. Insert the harness into the heater unit connector of
the camera.
4. Fold the desiccant pack in half, and attach it with
adhesive tape to point "A" shown in the figure.
Note: Attach the desiccant pack so that it does not
block ventilation holes or hang over the top of
the wall.
5. Attach the dome cover while paying attention not to
pinch the harness cable.
6. Connect the heater power cable of the camera. (See Connection.)
G Specifications
Required power:
Power consumption:
Dimensions:
Weights:
G Accessories
Fixing screw (M3 x 12) ...................................1 pc.
Desiccant pack .............................................1.pc.
24 V AC, 50 Hz
12.1 W maximum
29 mm (H) x 83 mm (W) x 89.5 mm (D)
[1-1/8" (H) x 3-1/4" (W) x 3-1/2" (D)]
45 g (0.1 lbs.)
-22-
Adhesive tape
Supplied screw
Fold
Point "A"
(inside the wall)
Harness
Advertisement
Table of Contents
