Kenmore 116.10701 Use & Care Manual page 14

CLEANING DUST BIN
A "N'N I
Turn off and unplug vacuum cleanerJ
before performing maintenance to theJ
vacuum cleaner. J
1. Remove the dust
bin.
2. Slide the lever in
the direction of the
arrow to remove
the embedded dust.
3. Push the filter release button, open the
dust bin.
Filter
Release
Button
Filter
4. Take out the cleaning brush (included) to
clean the dust filter.
5. Pushthe dust filter cover release latch to
pull out dust filter cover.
Dust Filter
Cover Release
Latch
6. Wash all _x_
parts of the
dust bin.
7. Allow filter to dry 24 hours before
putting back into vacuum cleaner.
NOTE: When the cleaning of the filter no
longer restores vacuum cleaner suction to
full power, replace the filter.
DO NOT operate without filter installed.
DO NOT wash in the dishwasher.
DO NOT install damp.
_lb CAUTION
° Do not attempt to dry with a hair
dryer or by placing in clothes dryer.
Hot air may cause the filters to warp.
° It is not necessary to wash after each
use.
Dust Filter
Cover
8. Install the dust
filter cover along
the inside of
locating strip, and
make sure you
hear a "click."
9. Close the dust
bin and reattach
it as shown.
- 14 -