Table of Contents
Advertisement
6
TROUBLESHOOTING GUIDE
Problem/
Possible
Symptom
Causes
Low output voltage
Overload
No output voltage
Low input
voltage
No output voltage
High input
and "fault"
voltage
indicator is lit
No output voltage
Thermal
when load is in
shutdown
excess of 200 watts
or 1.3 amperes
7
Solution
Reduce the load.
Recharge battery.
Check connections
and cable.
Make sure the inverter
is connected to a
12 volt battery.
Check regulation of
charging system.
Allow inverter to cool down
Improve ventilation—
make sure ventilation
openings in the inverter
are not obstructed. Lower
ambient temperature.
Maintaining Your Inverter
Your unit requires very little maintenance to keep
it operating properly. The exterior of the unit should
be cleaned periodically with
a damp cloth to prevent accumulation of dust and dirt. Keep
vents and fans free from dust or debris.
Product Service and Support
For any questions about operating or installing this new
Cobra product, PLEASE CONTACT COBRA FIRST...do not return
this product to the retail store. The contact information
for Cobra will vary depending on the country in which you
purchased and utilize the product. For the latest contact
information, please go to www.cobra.com/support
For products purchased in the U.S.A. you may also call
1-800-262-7212 (1-800-COBRA-12).
For Products Purchased in the U.S.A., if your product should
require factory service, please go to www.cobra.com/support
and follow the instructions for returning your product to the
Cobra Factory Service Department for service.
WARNING: This product contains lead, a chemical known to the State of California to
cause cancer and birth defects or other reproductive harm. Wash hands after handling.
MAINTENANCE & SERVICE
7
8
Advertisement
Table of Contents
