Impedance Change; (F-2000Bt, F-2000Btwp, F-2000Wt, And F-2000Wtwp Only); About The Input Overload Protection Circuitry; (F-2000B, F-2000W, F-2000Bt, And F-2000Wt Only) - Toa F-2000B Operating Instrucctions

Hide thumbs Also See for F-2000B:

Table of Contents

5. IMPEDANCE CHANGE

To change the impedance, use a standard screwdriver to rotate the rotary switch on the speaker's rear to

select the desired input power.

Note: The switch is factory-preset to 170 Ω.

[F-2000BT and F-2000WT]

CAUTION

• Never set the rotary switch to the "8 Ω" position when connecting the F-2000BT or F-2000WT to the

amplifier's high-impedance speaker line (70 V or 100 V line), as doing so may damage the speaker or

amplifier.

Be sure to set this switch to the "8 Ω" position when connecting to the amplifier's low-impedance line.

(F-2000BT and F-2000WT only)

• Never set this switch to the "83 Ω" position when operating the speaker on 100 V line.

Failure to follow this instruction could result in damage to the speaker or amplifier.

The speaker system features internal input overload protection circuitry for both high and low frequencies.

If an excessive input level is fed to the unit, the protection circuitry automatically cuts off the signal to the

speaker driver.

A drastic reduction in sound volume for the high or low frequency range indicates that the protection circuitry

has been enabled.

In such cases, simply reduce the amplifier volume. The protection circuitry will automatically reset in

approximately 10 seconds. After reset, maintain the volume at a level slightly lower than before.

Note

This protection circuitry does not completely protect the unit against input overload. Depending on the type or

duration of excessive power input, the protection circuitry might not be enabled, resulting in damage to the

speaker driver. Also, if the excessive power input continues for a long period of time, the circuitry may not be

capable of resetting to its original condition.

Take care so that the speakers are not exposed to excessive power input.

[F-2000BTWP and F-2000WTWP]

Table of Contents

F-2000w F-2000btwp F-2000bt F-2000wt F-2000wtwp