Optional Accessories - Makita DFR540 Instruction Manual

OPERATION
Driving operation
Fig.15
Switch on the tool by pulling the switch trigger. Hold the
tool squarely and firmly up against the driving surface. A
screw will be automatically carried to the driving position
and fastened.
CAUTION:
Always check the bit carefully for wear before
•
driving operations. Replace a worn bit or poor
fastening may result.
Always hold the tool squarely against the driving
•
surface. Holding it at an angle may damage the
screw heads and cause wear on the bit. This may
also lead to poor fastening.
Always keep the tool firmly against the driving
•
surface until the driving is over. Failure to do so
may cause insufficient fastening of screws.
Be careful not to drive a screw onto another screw
•
already fastened.
Do not operate the tool without screws. It will
•
damage the driving surface.
Do not apply oil or grease on the sliding surface of
•
the feeder box.
Driving in corner
Fig.16
This tool can be used to drive at a position 15 mm away
from the wall as shown in the figure.
CAUTION:
Driving at a position closer than 15 mm to the
•
wall or driving with the stopper base in contact
with the wall may damage the screw heads and
cause wear on the bit. This may also lead to poor
fastening of screws and malfunction of the tool.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.17
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
Fig.18
Use a screwdriver to remove two screws then remove
the front cover.
Fig.19
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
Fig.20
Use pliers to remove the carbon brush caps of the
carbon brushes. Take out the worn carbon brushes,
insert the new ones and replace the carbon brush caps
in reverse.
Fig.21
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
Fig.22
Reinstall the front cover and tighten two screws securely.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Drywall screw strip
•
Phillips bit
•
Various type of Makita genuine batteries and
•
chargers
Plastic carrying case
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
8
or attachments
Only use accessory or
are