Assembly - Husqvarna HU725AWDEX Product Manual

INSTALL STARTER ROPE (See Fig. 3)
1. Loosen T-knob.
2. Hold control bar against upper handle.
3. Slowly pull engine starter rope out until rope will slip
into loop of rope guide.
4. Tighten T-knob.
CONTROL BAR
ROPE GUIDE

ASSEMBLY

UPPER
HANDLE
T-KNOB
ENGINE
STARTER
ROPE
FIG. 3
TO PREPARE BATTERY (See Fig. 4)
NOTE: Your battery must be charged before you can start
your lawn mower.
1. Open port on electric start housing.
2. Con nect battery charger con nec tor (male) to bat tery
con nec tor (fe male).
3. Plug battery charger into 110 volt A.C. outlet.
• Leave battery charger connected for 24 hours before
starting your engine for the first time.
Connect your battery charger to charge battery as re quired.
IMPORTANT: THE ENGINE WILL NOT RECHARGE YOUR
BATTERY.
At the end of the mowing season the battery should be
charged for 48 hours to protect the battery during winter
storage.
ELECTRIC
START
HOUSING
BATTERY
CHARGER
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see "TO CON VERT MOWER" in the Operation section of
this man u al.
6
FIG. 4