Advertisement
Skyscan clocks do not receive or process radio controlled time signals from Germany's
DCF 77, Japan's J Ga AS, or England's MSFs atomically regulated transmitters. Skyscan
clocks can be manually set and used anywhere.
For more information on the NIST and radio controlled time, see
www.boulder.nist.gov/timefreq/
Set the time using the Manual Time Set button:
In some cases, the Skyscan clock may not receive the WWVB signal due to atmospheric
disturbances or hard to reach locations such as inside malls. In this case, please use the
Manual Time Set button, located at the back of the clock to manually set the time. To do
this:
1. Press and hold the Manual Set button.
2. The minutes and seconds hands will fast-forward. The seconds' hand will stop at 12.
The minute's hand will keep advancing.
3. Keep holding the Manual Set button until the time is set as required.
4. Release the button.
Note:
The clock will continuously search for WWVB each hour until a signal is received. Once
the WWVB time signal is received, the WWVB time will override the manual set time.
Advertisement
