SkyScan 88825 Instruction Manual

Atomic clock

Advertisement

Quick Links

Congratulations on purchasing the jumbo LCD wall clock. The utmost care has gone into the design and manufacture of
your clock. Please read these instructions carefully and store them in a safe place for future reference.

FEATURES

Precise Atomic Time display
Four separate time zones: Eastern, Central, Mountain or
Pacific
Calendar shows Month, Day & Date
Temperature shows in
Alarm clock and snooze function
Displays time in 12 or 24 hour format
Daylight Saving Time function (DST)
Indoor temperature

BATTERY INSERTION / REPLACEMENT

Remove the battery compartment cover on the back of the clock.
Insert three "AA" batteries into the battery compartment. Make sure the polarity is correct by following the (+ or -)
symbols engraved inside.
Do not mix old and new batteries or batteries of different brands.

RECEIVING RADIO SIGNALS AUTOMATICALLY

After inserting the batteries, the display will be activated, but the clock will not operate or set for the first four minutes.
During this time, it will automatically search for the WWVB time signal, and the antenna icon
While the clock is searching for the WWVB time signal, the "WAVE/+" button can be pressed to stop the search for the
WWVB time signal.
If the WWVB signal has been received successfully, the antenna icon
show the default time, date, and weekday.

STARTING THE SIGNAL SEARCH MANUALLY

In normal time display mode, you can also manually start the reception of the WWVB time signal any time: Press and hold
the "WAVE/+" button for 2 seconds. The antenna
signal and a solid antenna icon
NOTE: During the search for the WWVB time signal, the setting function will not operate! This is normal and not a
defect in your clock.
SKYSCAN ATOMIC CLOCK

Instruction Manual

O
O
F or
C
will displays on the LCD screen.
Model 88825
icon flashes until the clock has successfully received the WWVB time
will display continuously and the display will
will
flash.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 88825 and is the answer not in the manual?

Questions and answers

Summary of Contents for SkyScan 88825

  • Page 1: Instruction Manual

    SKYSCAN ATOMIC CLOCK Model 88825 Instruction Manual Congratulations on purchasing the jumbo LCD wall clock. The utmost care has gone into the design and manufacture of your clock. Please read these instructions carefully and store them in a safe place for future reference.
  • Page 2 (AM) radio reception is possible. The signal can reach approximately 2,000 miles through the internal antenna in the SkyScan Atomic Clock. However, due to the nature of the Earth’s atmosphere, reception is very limited during the daylight hours. The clock will search for a signal every night when reception is best.
  • Page 3 NORMAL OPERATION  Press and hold “DST/-” button for 2 seconds to turn on or turn off the Daylight-saving time (DST) function. Unless you live in an area that never recognizes daylight-saving time, such as Arizona, the DST function should always be turned on.
  • Page 4 Snooze function If alarm is activated, it will sound when set alarm time arrives. Pressing the “SNOOZE” button will activate the snooze function. Then the icon flashes and the alarm will stop. It will ring again after 5 minutes. SETTING TIME ZONE Choose the time zone by sliding the SELECTOR BAR on the back of the clock to the desired time zone.
  • Page 5 CARE OF YOUR CLOCK  Replace the batteries promptly when necessary or store the clock without batteries when not in use.  A soft cloth or a paper towel may be used to clean your clock. Do not use any corrosive cleanser or chemical solutions on the clock.

Table of Contents

Save PDF