1. Access the drive bays by
sliding the faceplate up until it
unlatches from the device.
. Once the faceplate is unlatched,
pull it off of the device, exposing
the drive bays.
3. Insert a 3.5" SATA hard drive into
each available drive bay. Make
sure to align the drive connectors
to the endpoints in the DNS-33.
Gently push the drive in until it
connects.
Note: If only one 3.5" SATA drive is available place this drive in the LEFT
bay while the opening (front) of the DNS-33 is facing you.
5
Hardware Installation