Silvercrest SUR 46 B1 Operating Instructions Manual page 6

__GRA76041_B4.book Seite 4 Montag, 27. August 2012 3:34 15
• This device is not designed to be used
by people (including children) with limit-
ed physical, sensory or mental capabili-
ties or people without adequate
experience and/or understanding unless
they are supervised by someone respon-
sible for their safety or are instructed by
them on how to use the device.
• Children must be supervised to ensure
that they do not play with the device.
• Keep the device out of the reach of chil-
dren.
DANGER of electric shock
due to moisture
• Protect the appliance from moisture,
water drops and water spray: failure to
observe this instruction may result in an
electrical shock hazard.
• The device, the power cable and the
mains plug must not be immersed in
water or any other liquids.
• If liquids enter the inside of the device,
pull the mains plug immediately. Have
the device checked before reusing.
• Never touch the device and mains plug
with wet hands.
• The stainless steel tank must not be
filled with water above the MAX mark-
ing, otherwise it may overflow during
the cleaning process.
DANGER of electric
shock
• Do not use the device if the device or
the power cable has any visible dam-
age, or if the device has previously
been dropped.
• Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating label.
The wall socket must continue to be
easily accessible after the device is
plugged in.
4
GB
• Ensure that the power cable cannot be
damaged by sharp edges or hot
points. Do not wrap the power cable
around the device.
• When using the device, ensure that the
power cable cannot be trapped or
crushed.
• When removing the mains plug, al-
ways pull the plug and never the cable.
• Disconnect the mains plug from the
wall socket...
... if there is a fault,
... when you are not using the device,
... before you clean the device, and
... during thunderstorms.
• To avoid any risk, do not make modifi-
cations to the device. You also must not
replace the power cable yourself. Re-
pairs must be carried out by a special-
ist workshop or the Service Centre.
• This device is not intended to be oper-
ated using an external timer clock or a
separate remote control system.
• Do not clean objects whose surfaces
show scratches, since these scratches
may deepen during the ultrasonic treat-
ment.
DANGER by ultrasonic
waves
• Do not touch the inside of the stainless
steel tank or the cleaning fluid during
the cleaning process: Ultrasonic waves
may cause injury to health.
WARNING! Risk of material
damage!
• Always use the basket inset for small
parts to prevent scratches on the parts
and the stainless steel tank. If several
parts are located in the cleaning fluid
during the cleaning process, these must
not be in contact to prevent scratches!
• Do not clean objects whose surfaces
show scratches, since these scratches
may deepen during the ultrasonic treat-
ment.