Switching The Tv Set On/Off - Loewe Connect 55 User Manual

Connect 40-55
User guide
Preparing the TV set / Switching TV set on/off
Connecting the TV set to the Home network
You may link your TV set to the home network by a wired connection
(Ethernet, Powerline adapters separately available) or by a wireless
radio connection (WLAN). Please contact your specialist dealer for
more information on Powerline.
Your Loewe TV set supports the UPnP AV standard for data playback
in the home network.
You call the network wizard to configure the network adaptor (System
settings Multimedia/Network
working).
Under no circumstances may the TV set be wired and at the
same time connected by a wireless connection to the same
network, e.g. router. This may cause severe operational faults!
Example for a wired connection
Connect the LAN socket of your TV set to the LAN switch/router of
your home network with a network cable (available from your dealer).
TV set
Example for a wireless connection
You can connect the TV set to your home network by a wireless radio
connection via the WLAN antenna inside the set.
Shadow effects of various materials, such as reinforced concrete,
metal surfaces, etc., attenuate the WIFI signal sometimes signifi-
cantly or completely.
WLAN router
TV set
Help for configuration problems
Loewe cannot provide any support for PC hardware and software or
network components owing to the diverse configuration options with
home networks.
Please contact the administrator of your home network and/or special-
ist dealer for support when setting up and for maintenance of network
connections, storage media, media server software and network devices
such as routers.
10
Network settings
LAN switch/router
PC
DSL
PC
DSL

Switching the TV set ON/OFF

Switching TV set to the standby mode
Press the mains switch at the bottom of the set.
The indicator in the control panel on the front side lights up white. The
set is now in standby mode.
Switching the TV set on/off via the local operating panel
Net-
Display
After switching on the TV set, it takes a few seconds for further oper-
ating commands to be processed (Exception: Quick Start Mode, see
below). Your TV set is ready to operate as soon as the status indicator
in the control panel lights up in green.
Switching the TV set on by means of the Remote control
Press the on/off key.
Or:
Press the TV key.
The previously watched station will be called.
Or:
Press numerical keys 1-9.
The corresponding station will be called.
After switching on the TV set, it takes a few seconds for further oper-
ating commands to be processed (Exception: Quick Start Mode, see
below). Your TV set is ready to operate as soon as the status indicator
in the control panel lights up in green.
Switching the set off with the remote control (Standby)
Press the on/off key.
Before switching off the set with the mains switch,
we recommend you to switch it to standby mode.
Switching TV set and connected additional devices off
(System Standby)
Press the On/Off key longer:
TV set and all CEC-enabled devices connected to the
HDMI ports will be switched off to standby (System
Standby).
Quick start mode
If you enable the Quick Start Mode and you switch on the TV set from
standby, the TV picture can be immediately seen without delay. You
can specify the times at which your device will be in the Quick Start
Mode. Please note that in this case you will have a higher energy
consumption.
You can find the Quick Start Mode under System settings
Quick start mode.
Default setting for the Quick Start Mode: off
To switch the TV set into Operating mode or
switch it off to Standby mode, press the
button on top of the TV set for about 2
seconds.
Control