Yamaha YST-SW320 Service Manual page 5

QQ
3 7 63 1515 0
Installation of power switch
Rapid cures bond (such as 5 minute epoxy) is required to fix the power switch.
As shown in Fig. A, apply rapid cures bond (such as 5 minute epoxy) to the power switch (the area which
contacts the rear panel), insert it in the rear panel and make sure it is fixed.
(Inserting the power switch in the rear panel only would not be sufficient for its secure installation.)
Precaution for installation of power cord
After connecting the power cord, be sure to apply the rapid cures bond (such as 5 minute epoxy) to the
cord stopper as shown in Fig. A,
Bond application diagram (Fig. A)
TE
L 13942296513
Dimensions
www
.
http://www.xiaoyu163.com
Apply rapid cures bond
340 (13-3/8")
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Glue List
Place
Cord stopper
Power switch
Q Q
3 6 7 1 3 1 5
Apply rapid cures bond
8
(5/16")
co
.
YST-SW320
9 4 2 8
Name
5 minute epoxy or
2051(Revertex Finewaters SDN.BHD.) or
VYLOK 917DH (National Starch &
Chemical (M) SDM.BHD.)
5 minute epoxy or Diabond 1620B
0 5 8 2 9 9 4 2 8
370 (14-9/16")
340 (13-3/8")
m
Units : mm (inch)
9 9
9 9
22
(7/8")
4