ASSEMBLY AND SET -UP
Adjusting the Handlebar Height
(Select models)
1
To adjust the height of the
handlebars, open the quick-release
lever and slide the T-bar to the
desired position and resecure the
quick release lever to lock into
place. When the T-bar is raised to
the maximum height, depress the
push button located directly below
the quick release lever to unlock
the T-bar.
Collar Clamp
Using a 5 mm Allen wrench, check that the collar clamp bolt(s) are tightened securely. This item is tightened and
quality inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused
the bolt(s) to loosen.
Note: The tension of the quick-
release lever can be adjusted by
manually tightening or loosening
the Allen bolt. Be careful not to
over-tighten. You should always
be able to open and close the
quick-release lever by hand and the
T-bar should slide freely when the
quick-release is open.
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.
WARNING:
Failure to properly install and/
or tighten the collar clamp
may cause the rider to lose
control and fall. If you are
having diffi culty understanding
these instructions, please
contact Razor Customer
Service for assistance.