Adjusting Handlebar Height; Collar Clamp - Razor Spark Owner's Manual

Hide thumbs Also See for Spark:

Manual (36 pages)

Owner's manual (8 pages)

Owner's manual (7 pages)

Table Of Contents

Table of Contents

ASSEMBLY AND SET -UP

Adjusting the Handlebar Height

To adjust the height of the

handlebars, open the quick-release

lever and slide the T-bar to the

desired position. Close the quick

release lever to lock into place.

When the T-bar is raised to the

maximum height, depress the

push button located directly

below the quick release lever to

unlock the T-bar.

Collar Clamp

Tools required: 5 mm Allen wrench

Using a 5 mm Allen wrench, check that the collar clamp bolt(s) are tightened securely. This item is tightened and quality

inspected at the factory however there is a slight chance that the effects of shipping or handling may have caused the

bolt(s) to loosen.

❑ Activating the Batteries (Spark 2.0 only)

Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information

at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service

contact information is listed at the back of this manual.

Spark_Series_MAN_US_141117.indd 4

Note: The tension of the quick-

release lever can be adjusted by

manually tightening or loosening

the Allen bolt. Be careful not to

over-tighten. You should always

be able to open and close the

quick-release lever by hand and the

T-bar should slide freely when the

quick-release is open. Unless T-bar

is fully extended.