SAF CFM-34-REBM Manual page 28

Mod {3|4} detect
Mod dump Show a list of modules and contents of their respective CPU registers (in
hexadecimal system). This command is for diagnostic purposes only.
Example:
SAF>mod dump
21, 02, CD, FF, 00, 00, 00, 00, 78, 00, 00, FF, 00, 01, 77, 03,
25, 01, E0, E4, E4, FF, 08, FF, FF, FF, FF, FF, FF, FF, FF, FF,
25, 02, E7, E6, E7, FF, 81, FF, FF, FF, FF, FF, FF, FF, FF, FF,
2B, 01, 00, E0, FF, 00, 00, 00, 00, 00, 00, 00, 00, 00, 00, 00,
IP addr <IPaddress>
IP mask <IPnetmask>
IP gw <IPaddress>
IP seraddr <IPaddress>
IP remaddr <IPaddress>
Route add <destinationIPaddr> Mask
[netmask] <gateway> [metric]
Route delete <destinationIPaddr>
[netmask]
SNMP community read
<communityname>
SNMP community write
<communityname>
SNMP trap <IPaddress>
Configuring E1 Interface Module parameters
Command
Mod {3|4} setE1 {Aloop | Dloop |
Off}
Mod {3|4} setE1 {120 | 75}
Mod {3|4} setE1 TxAIS {on | off}
Modular Fast Ethernet Bridge Management System Technical Description and Configuration Guide
Detect and show current settings, - displays a list of settings of the
respective interface module. The detection procedure is carried out
each time when IDU is started up. This command is for diagnostic
purposes only.
Set the IP address of Ethernet management port (requires
to restart the management module CPU).
Important!: Do not enter address "255.255.255.255"
Set the IP netmask of Ethernet management port (requires
to restart the management module CPU).
Set the IP address of the default gateway to the service
channel (requires to restart the management module CPU).
Set the IP address of the serial port of service channel for
the local (near-end) IDU management module (requires to
restart the management module CPU).
Set the IP address of the serial port of service channel for
the remote (far-end) IDU management module (requires to
restart the management module CPU).
Add a static route to the routing table. The variable
"metric" is set to 1 by default (requires to restart the
management module CPU). Example:
Route add
155.13.79.13 5
Delete a static route from the routing table (requires to
restart the management module CPU).
Specify the SNMP community name of the agent to enable
parameters to be read (not configured). The default
community name to read parameters is saf-public
Specify the community name of the agent to enable
parameters to be read and/or written (configured). The
default community name for read/write is saf-private
Set the IP address of the management terminal with the
installed Trap Manager software, based on SNMP platform
(requires to restart the management module CPU).
Description
Set the analog, digital or remote loopback in the module
(Aloop – analog loopback; Dloop – digital loopback, off –
disable current E1 module loopback).
Example: Mod 3 setE1 Dloop
Set the impedance of E1 interface, 120 Ω or 75 Ω.
Enable/Disable
configuration and testing purposes only).
V. 3.12. 1.0 · © SAF Tehnika A/S 2003
192.168.205.010 Mask
the transmission of
255.255.255.0
AIS signal (for
28