Arcom Communications No-Nonsense License Agreement For The Operating Firmware Of The Rc210 Repeater Controller - Arcom RC210 Hardware Manual

Note: If you don't have access to test equipment, you can temporarily adjust the receiver buffer trimpots to the midpoint and adjust the
transmit trimpots so the repeated audio "sounds the same" as does your radio when transmitting direct. But be sure to set these levels with
the proper test equipment before deploying your repeater!
The Tone trimpot adjusts the level of courtesy tones and CW ID's. You should adjust it for +/- 3 Khz deviation.
The Play trimpot adjusts the level of the output of the speech chip. You can adjust this for a comfortable level while the
controller is speaking (you can enter a command that causes the controller to speak in order to adjust this level).
Note: If you have set the discriminator and transmit audio levels correctly, the levels of tones and speech should be identical on all 3
ports.
ARCOM COMMUNICATIONS NO-NONSENSE LICENSE
AGREEMENT FOR THE OPERATING FIRMWARE OF THE
This license statement and limited warranty constitutes a legal agreement ("License Agreement") between you (either as an
individual or a single entity) and Arcom Communications for the software product ("Firmware") identified above, including any
software, media, and accompanying on-line or printed documentation.
BY DOWNLOADING OR OTHERWISE USING THE FIRMWARE, YOU AGREE TO BE BOUND BY ALL OF THE TERMS AND
CONDITIONS OF THIS LICENSE AGREEMENT.
Upon your acceptance of the terms and conditions of the License Agreement, Arcom Communications grants you the right to
use the Firmware in the manner provided below.
This Firmware is owned by Arcom Communications and is protected by copyright law and international copyright
treaty. Therefore, you must treat this Firmware like any other copyrighted material (e.g., a book), except that you
may either make copies of the Firmware solely for backup or archival purposes or transfer the Firmware to a single
hard disk provided you keep the original solely for backup or archival purposes.
You may transfer the Firmware and documentation on a permanent basis provided you retain no copies and the
recipient agrees to the terms of this License Agreement. Except as provided in this License Agreement, you may not
transfer, rent, lease, lend, copy, modify, translate, sublicense, time-share or electronically transmit or
receive the Firmware, media or documentation.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, ARCOM COMMUNICATIONS DISCLAIM ALL OTHER
WARRANTIES AND CONDITIONS, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE, AND NON-INFRINGEMENT,
WITH REGARD TO THE FIRMWARE, AND THE PROVISION OF OR FAILURE TO PROVIDE SUPPORT SERVICES. THIS
LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHERS, WHICH VARY FROM
STATE/JURISDICTION TO STATE/JURISDICTION.
LIMITATION OF LIABILITY TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL ARCOM
COMMUNICATIONS OR ITS SUPPLIERS BE LIABLE FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL
DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS PROFITS,
BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, OR ANY OTHER PECUNIARY LOSS) ARISING OUT OF
THE USE OF THE FIRMWARE OR INABILITY TO USE THE FIRMWARE PRODUCT OR THE PROVISION OF OR FAILURE
TO PROVIDE SUPPORT SERVICES, EVEN IF ARCOM COMMUNICATIONS HAS BEEN ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES.
RC210 REPEATER CONTROLLER
IMPORTANT - READ CAREFULLY
19